[RTL8722CSM] [RTL8722DM] Watchdog Timer Simple Example

Materials

  • Ameba D [RTL8722 CSM/DM] x 1

Example

In this example, we will use this simple watchdog timer example runs on the Ameba RTL8722 module to illustrate how to use the watchdog API. Before we get into the details of the example, let’s briefly go through the definition of Watchdog as well as it’s working principles.

Watchdog

Watchdog Timer (WDT) is a hardware timer that is used to detect the occurrence of a software fault, then automatically generates a system reset or a watchdog interrupt on the expiry of a programmed period.

In layman terms, imagine in the situation while your micro-controller is confused in an infinity loop, or any case like the micro-controller hang while performing some tasks. The normal troubleshooting method would be to press the reset button and jump out of the infinity loop. However, is it practically impossible to do press on the button all time, therefore, the watchdog timer that embedded inside the micro-controller would help with this situation.

1

Feed the Dog

If you have a dog in your home. You need to feed that dog at a regular interval. if you can’t feed one day, it will bite you! And likewise, this is the working logic behind the watchdog timer.

In our example, we created 2 tasks that contain some loop that runs over and over again, one is called a successful task and the other is a failed task. We are enabling the watchdog timer is loaded with an initial value (5 seconds) greater than the total delay in the successful task, but shorter than the failed task.
For the successful case, the watchdog is being refreshed/feed within 5 seconds, however, for the failed case, the loop is under processing and the watchdog is not being fresh after 5 seconds, which triggers the watchdog (dog barks), an interrupt is generated to reset the processor. Likewise, the watchdog timer protects the micro-controller from the hanging case.

Then we move to the coding part for this example, for this example, you will only need the Ameba RTL8722 board itself.

1

Firstly, make sure the correct Ameba development board is selected in Arduino IDE: “Tools” -> “Board” -> “RTL8722CSM/RTL8722DM”. Then open the “Watchdog Timer” example in “File” -> “Examples” -> “AmebaWatchdog” -> “Watchdog Timer”:

1

Upon successfully upload the sample code, open the serial monitor, and press the reset button. You will find that the successful task (small task) can refresh the watchdog within the 5 seconds (initialized in the watchdog timer). However, the failed task (big task) will not be able to refresh the watchdog within 5 seconds, which leads to the microcontroller reset.

1